Resubmitted mesh

Please only do problems 3.48, 3.49, 3.51, 3.52, 3.54, 3.57, 3.60, 3.61. OK PLEASE show all equations used, work and PLEASE do not skip steps no matter how minor. I learn by example and need to see everything also including pictures of current flow, directions, picture of how each step progressed, etc.. Please just do not give ...continues

Resubmitted mesh

Please only do problems 3.62, 3.63, 3.68, 3.69, 3.71, 3.72, 3.74. PLEASE show all equations used, work and PLEASE do not skip steps no matter how minor. I learn by example and need to see everything also including pictures of current flow, directions, picture of how each step progressed, etc.. Please just do not give an answe ...continues

Nodal by inspection

Do problem by inspection method and show all steps and solutions please.

Solve the circuit shown using the method of superposition and find the current i through the 50 ohm resistor.

Solve the circuit shown using the method of superposition and find the current i through the 50 ohm resistor. See attached file for full problem description.

On the circuit shown, VS(t) = 100 sin (t) Volts and is(t) =2 cos (1000t) Amps.

On the circuit shown, VS(t) = 100 sin (t) Volts and is(t) =2 cos (1000t) Amps. Use the superposition to find the voltage vC(t) across the capacitor. See attached file for full problem description.

Thevenin Equivalents

Source transformation of the 10 A current source. See attached file for full problem description.

Norton equivalent

Norton equivalent. See attached file for full problem description.

Derive an expression for the transfer function of a circuit

a. Derive an expression for the transfer function of the circuit (attached). Simplify the expression as far as possible but do not attempt to rationalise it. Refer to the two reactances as Xc1 and Xc2. b. Using the transfer function obtained in part (a) above, derive an expression for the phase angle of the output voltage. ...continues

Electrical/Current Flow Calculations

A typical 120-volt household circuit delivers 350 watts of power to an appliance, and another 10 watts of power are consumed by the circuit. There is no ground fault. a. How much current is carried by the hot wire? b. How much current is carried by the neutral? c. How much current is carried by the grounding conductor? d. ...continues

Is the battery supplying or consuming power?

See attached file for full problem description. Please answer only question 1.1