350 gpm of 120F water are being pumped through the system

Related BrainMass Solutions

• Advanced energy: Flow rate example questions

  370337 Advanced energy: Flow rate example questions What is the flow rate in GPM (gallon per minute) for the water to run through each of the reversible turbine generator (6 of them} in Ludigton's hydro pumped system, assuming the average height at 300

• Fluid Mechanics problem

  If the water is pumped with a speed of 0.45 m/s under a pressure of 400 torr from the first floor through a 6.0-cm diameter pipe, what will be the pressure on the next floor 4.0 m above in a pipe with a diameter of 2.0 cm?

• Critical Numbers, Derivatives and Rates of Change

  If the water level is rising at a rate of centimeters per minute when the height of the water is meters, find the rate at which water is being pumped into the tank in cubic centimeters per minute.

• Application of integration

  Work done in raising dw weight of water through a height y ft = ydw dw = Volume of water in the layer x Density of water* = ΠR2dy x ρ = Π(2.5)2x62.4xdy = 1225dy where ρ is the density of water in fps system = 62.4 lb/ft3 [* Definition of density

• Inlet velocity and flow from approach piping to the stilling well

  > The stilling well has a weir so that the water enters the first chamber of the stilling well, then overflows the weir to the 2nd chamber >Then the water enters the inlet to a diffuser tube bank which consists of 36 4" round diffuser tubes that are

• Anatomy: Portal Veins, Normal Veins, Blood Flow Control

  Blood flow is often measured as general speed and volume pumped through a certain point over a certain period of time.

• Basic Water Distribution Math for Water Distribution Operator Certificate

  Problem 24: A tank is filled at the rate of 1-foot 6-inches per hour. The tank is empty at 8 AM. How many million gallons of water are in the tank at 5 PM if the diameter of the tank is 180 feet?

• Heat energy needed to raise water temperature from 50 degrees F to 212 degrees F?

  129759 Heat energy needed to raise water temperature 100 gallons per minute flow of water at 50 degrees F passes through a theoretically 100% efficient heat exchanger.

• Rate of Rising Water Level

  248016 Rate of Rising Water Level 7. A water softener tank is basically a cylinder of height five feet and diameter 2.5 feet. Water is being pumped into the tank at a rate of 2 cubic feet per minute.