Purchase Solution

Statics : Equilibrium of Beam with Distributed Load

Not what you're looking for?

Ask Custom Question

Please see the attached file for the fully formatted problem on the forces of a beam.

Attachments
Purchase this Solution
Solution Summary

Equilibrium of a beam with a distributed load is investigated via handwritten calculations and diagrams attached as a .zip file.

Purchase this Solution
Free BrainMass Quizzes
Introduction to Nanotechnology/Nanomaterials

This quiz is for any area of science. Test yourself to see what knowledge of nanotechnology you have. This content will also make you familiar with basic concepts of nanotechnology.

The Moon

Test your knowledge of moon phases and movement.

Intro to the Physics Waves

Some short-answer questions involving the basic vocabulary of string, sound, and water waves.

Classical Mechanics

This quiz is designed to test and improve your knowledge on Classical Mechanics.

Basic Physics

This quiz will test your knowledge about basic Physics.

View More Free Quizzes
Related BrainMass Solutions

  • Cross-Beam Systems

    150013 Cross-Beam Systems With respect to the cross-beam system shown in the Figure (see attached), if L_B - 4(L_A), what part of the total load P is carried by beam A? By beam B?

  • Determining Stress at Point A

    304820 Determining Stress at Point A The L-shaped cross section beam seen below supports a distributed load w. The load line of the distributed load is at a 70 angle with the horizontal axis and does not cause any torsion in the beam.

  • Wooden beam under constant load at an angle

    3619 Wooden beam under constant load at an angle A 150  200 mm wooden beam shown in Fig 9-4 (a) is used to support a uniformly distributed load of 4 kN (total) on a simple span of 6000 mm.

  • Universal Beam Section: Bending, Maximum Stress

    The beam is simply supported at each end over a length of 5 m and carries a uniformly distributed load of 10 kN m-1 (including its own weight) over its whole length. Modulus of elasticity (E) = 210 GN m-2.

  • Shear Force and Bending

    It carries a load that is uniformly distributed over part of the beam together with two concentrated loads: (See attached file for full problem description with diagram) Using convenient scales, construct the Shear Force and Bending Moment diagrams

  • Measurements of Beams

    A) 183 psi C B) 1.32 ksi T C) 2.21 ksi T D) 2.21 ksi C 3) A timber beam is simply supported and carries a uniformly distributed load w of 360 lb/ft over its entire 18-ft span.

  • Simply supported beam: Maximum bending moment

    293860 Simply supported beam: Maximum bending moment The bending moment M at position x m from the end of a simply supported beam of length L m carrying a uniformly distributed load of w Kn m-1 is given by M = w/2 L (L-x) - w/2 (L - x)^2 Show that

  • Bending Moment

    294140 Determine Maximum Bending Moment: Example Problem The bending moment M at position x m from the end of a simply supported beam of length L m carrying a uniformly distributed load of w Kn m-1 is given by: M = w/2 L (L-x)- w/2 (L - x)^2 Show

  • Statics - Finite Elements Methods : Beams and Springs

    The figure shows a beam element with the following properties: E=200 GNm2,I = 5-l0m4, L = 4m, A=250 mm2 and a bar element with: A = 500 mm2, E 200 GNm2. Find: 1. The stiffness matrix of each clement in the local (element) coordinate system. 2.

View More Related Solutions